Aurkitu AZTERLANeko lan-taldeak sortutako teknologiak, materialak eta diseminazio ekintzak.
Relationship between casting modulus and grain size in cast A356 aluminium alloys
Microstructure of Al-Si alloy castings depends most generally on melt preparation and on the cooling rate imposed by
Effect of various dopant elements on primary graphite growth
Five spheroidal graphite cast irons were investigated, a usual ferritic grade and four pearlitic alloys containing Cu and
Effect of alloying on mechanical properties of as-cast ferritic nodular cast irons
The development of low temperature applications for ferritic nodular cast irons calls for improved materials in the as
Chunky graphite formation in small section ductile iron castings
Chunky graphite is a degenerated graphite form which can be found in the thermal centre of ductile iron
Influence of the chemical composition of different steel scraps on the mechanicalproperties of ductile iron
Different commercial steel scraps have been selected so as to analyse the outcome of their use as raw
Improved Analytical Method for Chemical Analysis of Cast Irons Application to Castings with Chunky Graphite
Chunky graphite is a particular form of graphite degeneracy that appears in the centre of large iron castings,
Design of a mould for the study of the relationship between thermal analysis results and microstructure of aluminium alloy A357 in investment casting
Melt treatment of aluminium alloys is essential for optimizing their mechanical properties. Thermal analysis methods usually used as
Effect of selected alloying elements on mechanical properties of pearlitic nodular cast irons
There is a continuous demand for low-cost nodular cast irons with improved mechanical properties, this being an industrial
Microstructure investigation of small section nodular iron castings with chunky graphite
Parameters that affect chunky graphite formation in heavy-section castings have been studied in previous works which showed that
Mechanical properties optimization of alloys AlSi7Mg casting in sand moulds
MechanicalpropertiesoptimizationofalloysAlSi7MgcastinginsandmouldsAbstractIn the present work the mechanical properties of the alloy AlSi7Mg were studied in order to choose a
Durangaldeko airearen kalitatearen kontrola
Gaur, Durangaldean kalean egindako airearen kalitatea kontrolatzeko kanpainen emaitzak aurkeztu nahi ditugu: Aste Berdearekin eta Mugikortasun Iraunkorraren Europako
Experimental investigation on the effect of copper upon eutectoid transformation of as-cast and austenitized spheroidal graphite cast iron
Copper is known as a pearlite promoter in cast iron and has been used as such for a
Thermal analysis as a microstructure prediction tool for A356 aluminium parts solidified under various cooling conditions
Thermal analysis performed with standard cups has been used since decades for melt control and microstructure prediction before
Thermal and structural studies about the solidification process of grey cast irons
The grey iron casting manufacture is an industrial process extendly used today. Therefore, the study of the solidification
Comparison of thermal analysis and differential thermal analysis for evaluating solid fraction evolution during solidification of Al-Si alloys
Both thermal analysis (TA) and differential thermal analysis (DTA) have been used since long to evaluate latent heat
Carbon content control during the production process of high carbon brake discs
The physical properties of high carbon brake discs are strongly affected by the content of this element, including